Closed cell foam is much denser than open cell foam.
Open or closed cell foam for attic.
Light density open cell spray foam insulation and medium density closed cell spray foam insulation.
This type of spray polyurethane foam can be classified into two different types.
Open cell foam weighs 1 2 pound per cubic foot and closed cell weighs 2 lbs per cubic foot.
I have open cell in my house since 2004 and i would not use it in a dogs out house.
There you have it.
If you do not use the attic for a habitable purpose you might want to keep your thermal barrier on the floor of the attic.
These two types of spray foam insulation both contain polyurethane that can be potentially dangerous to the environment and to health upon exposure.
The myth that open cell is more economical is bullshit.
A foams r value is its resistance to heat flow or in other words how well they insulate.
Open cell spray foam is a perfectly acceptable insulation product to use in attics.
Closed cell foam can be over three times that with a density of 1 75 pounds per cubic foot or more.
Open cell foam has an r value of about 3 5 to 3 7 per inch while closed cell foam has an r value of about 6 per inch.
Closed cell foam can also increase the racking strength of attic walls which.
Using spray foam insulation in an unvented attic application.
Closed cell foam has a higher r value than open cell foam usually about 6 0 per inch.
Do it right and your roof will not rot.
Both low density open cell and medium density closed cell spray foam can be used in an unvented attic to provide the needed thermal resistance and airtightness.
There is 300 difference there but the cost they give you is about a third difference and open cell foam at 12 inches will not give you the performance of 2 inches of closed.
Others like david butler see his comment below say you need to do it only if a moisture problem develops.
Lstiburek says to do it for every spray foam attic.