Nyc ada door handle height.
Door closers and door stops shall be permitted to be 78 inches minimum above the finish floor or ground.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
4 13 6 is there at least 18 inches of clear wall space on the pull side of the door next to handle.
Hardware required for accessible door passage shall be mounted no higher than 48 in 1220 mm above finished floor.
4 13 4 if double leaf door is present at least one door must be 32 inches minimum.
Locks used only for security purposes and not used for normal operation are permitted at any height.
Lever operated mechanisms push type mechanisms and u shaped handles are acceptable designs.
Access doors or gates in barrier walls and fences protecting pools spas and hot tubs shall be permitted to have operable parts of the release of latch on self latching devices at 54 inches.
When sliding doors are fully open operating hardware shall be exposed and usable from both sides.
Locks used only for security purposes and not used for normal opera tion are permitted at any height.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
Pre existing locks most likely not applicable to new builds gates protecting pools spas and hot tubs are allowed to be a bit higher up to 54.
The edge must be beveled 1 2 maximum above a height of 1 4.
A few exceptions are included in the bill.
There is one notable difference between the 2003 code and 2010 code.
Ada door handle height requirement.
Thresholds 404 2 5 the height of thresholds is limited to 1 2 in new construction.
Handles pulls panic bars door hardware ada compliant locks exit devices handles pulls latches and other operable parts on doors shall comply operable parts of such hardware shall be 34 inches minimum and 48 inches maximum above the finish floor or ground.
The height of the door handle must be between a minimum of 34 and a maximum of 48.
Door and gate hardware 404 2 7 the most important aspect of this section is the mounting height for operable parts pulls handles etc they need to be a minimum of 34 and a maximum of 48 above the finished floor.
